How to disassemble the washbasin faucet?

1. Close the water inlet valve
Before replacing the washbasin faucet, first close the water inlet valve. The water inlet valve is located under the kitchen countertop. However, according to the editor's understanding, if the valve is not tightly closed or cannot be closed, it can be operated with water, but when installing the new faucet, it must be prepared in advance with raw material tape around 7-8 turns in the thread direction (less winding is easy to seepage), A large bucket should be prepared under the water pipe to collect water to prevent waste; in addition, when the valve cannot be closed, be sure to open a new faucet and other faucets to divert and reduce pressure.??

Brass Basin Faucet With Soap Dispenser

2. Removing the washbasin faucet
1: First use a wrench to separate the water inlet pipe and the hose. The water inlet pipe of the bathroom is an open pipe, which can be shaken by hand. When disassembling, it is afraid that it will break accidentally. Therefore, when disassembling, I was very careful, holding the water pipe with my left hand and twisting the wrench with my right hand to easily separate the two.??

2: Separate the water inlet pipe and the hose, and remove the fixture of the faucet, so that the faucet can be removed from the basin. But then there is a problem. The hose of the faucet has been used for a long time, so the hose has become brittle, and the fixing part has been rusted, and it cannot be unscrewed with a wrench.??

3: Separating the faucet and the basin, it is difficult to operate due to the small space under the basin. Moreover, the glass glue between the basin and the countertop has been worn out for a long time, so the basin can be easily removed from the countertop. After the basin is removed, the construction will not get in the way. Then use a saw to cut off the rusted part that is difficult to remove, and the faucet is successfully removed.